Basic operating principles of the robot mower: The robot mower selects its driving pattern at random. This means it does not follow any specific pattern but moves randomly around the garden. This ensures that over a week of mowing, it will cover the entire lawn area within the boundary wire.
Driving to the Charging Station
When the battery is depleted, the robot mower will automatically find the boundary wire and drive counterclockwise back to the charging station. It will recharge and then continue the mowing cycle.
Detection of Boundary Wire
As the robot mower approaches the boundary wire, the sensors installed on the front of the cover will detect it. However, to ensure an optimal mowing result, the robot will drive approximately 10-12 cm beyond the boundary wire with the front (where it does not mow).
It is important to take this into account when the user lays the boundary wire in the garden.
Stop the Robot
The robot mower is stopped by pressing the red STOP button, regardless of whether it is mowing or on its way back to the charging station.
Setting the Cutting Height
The robot mower can be set to a cutting height between 20-60 mm. If the grass is taller than 60 mm when the robot is installed, it is necessary to first cut the grass with a regular lawn mower to avoid overloading the robot's blades and to achieve a satisfactory mowing result, as well as to prevent the machine from getting stuck. It is recommended to start by setting the cutting height to max (60 mm) and gradually lower the cutting height over a few days until the desired grass height is achieved.
The cutting height is adjusted by pressing the STOP button (if the robot is running). When the robot is stationary, the cutting height can be adjusted by turning the height adjustment knob on top of the robot (see the image). The robot mower can cut grass even when it is wet, but this will lead to greater accumulation of grass under the robot, increased friction on the blades, higher noise levels, and an increased risk of the machine getting stuck. Remove the grass with a soft brush (always turn off the robot completely before working near the blades).
Mowing Limitations for the Robot Mower
If you and your neighbour both have a robot mower, there should be at least 1 metre between the boundary wires to avoid signal interference.
Set up the charging station at least 10 metres from the neighbour's boundary wire.
If the neighbour's robot mower is from a different manufacturer, maintain a distance of 2 metres to avoid interference.