E1 Outside working area
1. Please place the lawnmower within the boundary wire
2. Ensure that the red and black connecting wires are not reversed.
E2 Wheel motor is blocked
1. Turn off the lawnmower; take the lawnmower to an area free of obstacles.
2. Turn on the lawnmower. Press START and then OK.
3. If the error persists, turn off the power; turn the lawnmower upside down and check for anything that prevents the wheels from turning.
4. Remove any obstacles, turn the lawnmower upright, turn on the power and press START and then OK.
E3 Cutting motor is blocked
1. Turn off the lawnmower.
2. Turn the lawnmower upside down and check for anything that prevents the blade disc from turning.
3. Remove any obstacles.
4. Turn the lawnmower upright and take it to an area with shorter grass or adjust the cutting height higher.
5. Turn on the lawnmower. Press START and then OK.
E4 Bump sensor is activated
1. Turn off the lawnmower.
2. Take the lawnmower to an area of your lawn without obstacles.
3. Remove the cover and check the magnet on the back of the cover. If there is no magnet, contact after-sales service to replace the cover.
4. If the magnets are in place, check that the connection of the rubber holders between the cover and the lawnmower is secure. If loose, please reattach them correctly.
5. Turn on the power. Press START and then OK.
E5 Lifted
1. Turn off the lawnmower.
2. Take the lawnmower to an area free of obstacles.
3. Turn on the lawnmower. Press START and then OK.
4. If the error persists, turn off the lawnmower.
5. Turn the lawnmower upside down. Check for anything that prevents the front wheels from turning.
6. Remove any obstacles, turn the lawnmower upright, turn on the power and press START and then OK.
E6 Upside down
1. Turn the lawnmower so that it stands on its wheels.
2. Press START and then OK.
E7 Angle sensor is activated
1. Turn off the lawnmower.
2. Check that the slopes of the ground do not exceed the required limits.
3. Take the lawnmower to a flat area.
4. Turn on the lawnmower. Press START and then OK.
E8 Docking error
- Check if there is a 1 metre straight wire in front of the charging station.
- Check that there is no rust/oxidation on the charging poles.
- Check that the charging station is positioned horizontally.
- Check that the charging station is not bent.
E9 Stuck
1. Place the lawnmower in an area free of obstacles.
BP Battery protection
1. Check the battery temperature. If the temperature is too high, wait until the battery has cooled down. If the temperature is too low, wait until the temperature is above 5 ℃.
E11 No boundary signal
1. If the lawnmower is inside the working area, check the charging station's light. If the diode blinks red, it means that the boundary wire is not connected correctly to the charging station.
2. If it is connected correctly and the light still blinks red, check if the boundary wire is broken.
E12 Battery error
Contact service to replace the battery.
E13 Charging error
1. Check if the poles on the charging station are clean; if not, they should be sanded with fine sandpaper to ensure a good connection.
2. If the error persists, contact customer service.
E14 Exceeds usable area
1. Reduce the lawnmower's working area as specified in the manual.
2. If the error persists, contact customer service.
EE Unknown error
1. Restart the lawnmower.
2. If the error persists, contact customer service.
LOCK Continuous entry of incorrect passwords
1. Keep the lawnmower ON for 10 minutes continuously.
2. After 10 minutes, you can enter your password again.
3. If you have forgotten your password, contact customer service.